4
S
4
S
-26
°
-24
°
-21
°
-18
°
-15
°
-13
°
E
F
G
D
C
B
A
G
= Refrigerator temperature control knob
A
= ÇAppliance in operationÈ light
B
= Freezer alarm light
C
= Freezer electronic thermometer
D
= Fast Freeze indicator (S)
E
= Main On/Off switch
F
= Freezer and Fast Freeze (S) temperature control
knob
OPERATION
Starting up
¥ Turn switch E until the pointer is opposite the ÇIÈ
symbol (pilot lights A and B will come on).
¥ Turn refrigerator temperature knob G and freezer
temperature knob F to the required position; in
general a mid position is best (the lower the
number, the warmer the temperature).
¥ Pilot light D comes on when knob F is tumed to
position ÇSÈ.
The refrigerator and freezer are switched off by
turning switch E to position ÇOÈ.
Control Panel
Cleaning the interior
Before using the appliance for the first time, wash
the interior and all internal accessories with luke-
warm water and some neutral soap so as to remove
the typical smell of a brand-new product, then dry
thoroughly.
Do not use detergents or abrasive
powders, as these will damage the finish.
Warning light
The alarm light B indicates when the temperature
inside the freezer compartment has risen to a point
at which safe storage of frozen foods can no longer
be guaranteed. When the appliance is first started
up, or after having loaded a quantity of food to be
frozen, this warning light will stay on until a safe
storage temperature has been reached.
Electronic thermometer
The electronic thermostat C consists of 6 pilot lights.
Each light corresponds to a temperature inside the
freezer. Frequent or prolonged opening of the doors
may slightly modify the temperature indicated.
Temperature variations can also occur if excessive
quantities of food are loaded into the freezer (see
freezing capacity).
17
¥ If using a 100 mm plinth, fit the complete height
compensation strip.
Alignment height of 870 mm
¥ If using a 190 to 220 mm plinth, make a shown.
¥ If using a plinth higher than 150 mm but less than
190 mm, cut the height compensation strip
supplied with the appliance to the required depth
and fit it between the plinth and the ventilation
grille.
¥ If using a 150 mm plinth, fit the complete height
compensation strip.
¥ If the appliance is installed at the end of a row of
units, insert foot E to hold the plinth in place.
100
150
30
100
E
