48
Door reversibility
Before carrying out the operations described below,
pull out the mains plug from the wall socket.
To carry out door reversal operate as follows:
Remove the ventilation grill (D);
Remove bottom hinge (E);
Slide out the lower door from middle hinge (H) and
remove the latter;
Slide out the upper door from pin (5), unscrew the
latter and then screw it down into the hinge provided
on the opposite side;
Remove the two plugs, to reveal the holes for the
hinge pivots, and remount them on the other side;
Refit the upper door and the middle hinge on the
opposite side;
Refit the lower door and bottom hinge (E) on the
opposite side.
Remove the plug (F) from the ventilation grill (D) and
replace it on the opposite side.
Re-assemble the ventilation grill (D).
Unscrew the handle. Refit it on the opposite side after
having pierced the plugs with a punch. Cover the
holes left open with the plugs contained in the
documentation pack.
Warning:
After having reversed the opening direction of the
doors check that all the screws are properly
tightened and that the magnetic seal adheres to the
cabinet. If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly to the
cabinet. In that case, wait for the natural fitting of the
gasket or accelerate this process by heating up the
part involved with a normal hairdrier.
Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the serial number plate
correspond to your domestic power supply.
Voltage can vary by
±
6% of the rated voltage.
For operation with different voltages, a suitably sized
auto-transformer must be used.
Fig. 3
Fig. 4
Fig. 5
Fig. 6
5
D548
D405
H
E
F
D
D640
F
F
F
PR228
TECHNICAL SPECIFICATION
The technical data is indicated in the rating plate on the left side inside the appliance.
GB