INSTALLATION
GB
If this appliance featuring magnetic door
seals is to replace an older appliance
having a spring lock (latch) on the door or
lid, be sure to make that spring lock
unusable before you discard the old
appliance. This will prevent it from
becoming a death-trap for a child.
Positioning
The appliance should be installed well away
from sources of heat such as radiators,
boilers, direct sunlight etc. Best performance
is obtained with ambient temperature
b18°C and +43°C (class T); +18°C
and +38°C (class ST); +16°C and +32°C
(class N); +10°C and +32°C (class SN). The
class of your appliance is shown on its
rating plate.
Ensure that air can circulate freely around
the back of the cabinet. To ensure best
performance, if the appliance is positioned
below an overhanging wall unit, the minimum
distance between the top of the cabinet and
the wall unit must be at least 100 mm (Fig. 1-
A). Ideally, however, the appliance should not
be positioned below overhanging wall units
(Fig.1-B). Accurate levelling is ensured by
one or more adjustable feet at the base of
the cabinet.
Important
It is essential that the appliance be
connected to an efficient earth tap. For this
purpose the supply cable plug incorporates a
special earth contact. If the sockets of your
domestic wiring system are not earthed,
have the appliance connected to a separate
earth wire by a qualified electrician in
accordance with existing safety regulations.
The Manufacturer declines all
responsibility if the above safety
precautions are not observed.
This appliance complies with EEC
directive number 87/308 of 2/6/87 relative
to radio interference suppression.
This appliance complies with the
following E.E.C. Directives:
- 73/23 EEC of 19.2.73 (Low Voltage
Directive) and subsequent mod)fications;
- 89/336 EEC of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.
Cleaning the interior
Before using the appliance for the first time,
wash the interior and all internal accessories
with lukewarm water and some neutral soap
so as to remove the typical smell of a brand-
new product, then dry thoroughly. Do not use
detergents or abrasive powders, as these will
damage the finish.
Rear spacers
In the bag with the documentation, there
are two spacers which must be fitted in
the two top corners.
Slacken the screws and insert the spacer
under the screw head, then re-tighten the
screws.
33
NP002
100 mm
10 mm
10 mm
A
B
D594
Fig. 1
Fig. 2
