8
Gas inlet pipe
Fibre washer
Test point adaptor
- ensure arrow is in
the right direction
Supply hose or
pipework with 1/2’
tapered thread
- sealed with thread
seal tape or
compound suitable
for gas connection
Connecting to a remote supply of LPG
The components required to make this type of connection
are available as an accessory and can be purchased either
on the Electrolux spare parts website or by contacting the
Electrolux Customer Service Centre. Refer to Accessories
section on page 17 for part numbers.
Never connect the barbecue to an unregulated LPG
supply. Ensure that the supply pressure at the inlet of the
barbecue is 2.75kPa.
Electrolux strongly recommends installation of a manual
shut-off valve, or hose assembly with a certified quick
connect that is accessible with the appliance installed, so
that the appliance may be isolated from gas in the event of
an emergency or for servicing.
The components required are
• Brass test point adapter
• Sealing washer
To assemble the connection:
• Connect the brass test point adapter to the barbecue
gas inlet with the arrow on the adapter oriented
according to direction of gas flow, with the sealing
washer in place to seal the connection.
• The inlet to the adapter has a standard internal ½”
pipe thread and can connect to any standard external
½” tapered threaded connection. This connection is
sealed with any thread tape or sealing compound that
is suitable for gas connections. Connect the fixed LPG
pipework to the inlet of the test point adapter by any
suitable means in accordance with requirements of
AS 5601.
• Leak test all connections in the assembly as described
under LEAK TEST PROCEDURE.
NATURAL GAS INSTALLATION
NOTE: Conversion of this unit to Natural Gas must be
carried out by a qualified licensed person and a Certificate
of Compliance must be issued to the owner on completion
of the installation and conversion.
Converting the Unit to Natural Gas
This barbecue is supplied set up for Universal LPG and
is labelled accordingly. A Natural Gas conversion Kit is
available as an accessory and can be purchased either
on the Electrolux spare parts website or by contacting the
Electrolux Customer Service Centre. Refer to Accessories
section on page 17 for part numbers.
The components required for conversion are:
• Natural Gas Regulator
• Small Plastic Bag containing a 2.10mm brass injector.
• Natural Gas Installation Pipe
• 2 x Sealing Washer
• 1 Natural Gas sticker.
To convert the appliance, proceed as follows:
1. Remove screw and cover panel on base of burner box.
Screw
Cover panel
