Electrolux EOD6332X, Instruction Booklet

Page: 7 / 44

7
THINGS YOU NEED TO KNOW
WARNINGS
·
This appliance must be installed by an authorised
electrician.
·
This appliance must be earthed.
·
Do not remove the screws from the earth tab
extending from the oven mains terminal block
(Fig. 5).
·
Before connecting the appliance make sure that
the voltage of your electricity supply is the same
as that indicated on the rating plate. This is
situated on the lower front frame of the appliance
and can be seen upon opening the door.
Alternatively the rating plate may also be found
on the back or top of some models (where
applicable).
·
Do not alter the electrical circuitry of this
appliance.
THINGS TO NOTE
·
This appliance is designed to be fitted in cabinets
of the recommended dimensions as shown (Fig.
1).
·
If your cabinet interior dimension is between 565-
570mm the oven may still be fitted. However a
minor modification to the cabinet will be required
to reduce the aperture size down to 560-565mm.
To allow the product to be securely screwed into
the cabinet.
·
The dimensions given provide adequate air
circulation around the unit within the cabinet,
ensuring compliance with BS-EN60 335.
·
Enquiries regarding the installation of the cooker
point, if required, should be made to your
Regional Electricity Company to ensure
compliance with their regulations.
·
The cooker socket switch should be outside the
cabinet but within 2m of the appliance to make it
accessible to switch off the appliance in case of
an emergency.
·
To protect the hands, wear gloves when lifting
the oven into its housing.
NOTE: HOUSE CIRCUIT
Earth leakage and continuity tests must be carried
out before the appliance is connected to the mains
supply and re-checked after fitting.
GETTING THINGS READY
ELECTRICAL CONNECTION
·
The appliance should be operated using at least
4mm
2
twin core and earth PVC insulated
multicore cable.
A means of disconnection with a contact separation
of at least 3mm must be supplied in the fixed wiring.
Wiring connections must be in accordance with
AS/NZS 3000 Wiring Rules and any particular
conditions of the local authority.
PREPARING CABINET FOR FITTING OF OVEN
·
Make sure that the cabinet is the correct size for
the appliance to be fitted (Ref. Fig. 1).
·
If the cabinet is between 565-570mm, then the
cabinet should be modified so that at the screw
fixing points the recommended dimension of at
least 560-565mm is maintained. The
modification should ideally be localised to ensure
that after screw fitment the oven is
securely
fixed into position.
·
The cabinet must be stable and level securing it
to the wall or floor. If necessary, make
arrangements to ensure the shelf upon which the
oven will rest is level.
·
When the appliance is installed ensure a
minimum gap of 2mm is maintained between the
trim on the bottom edge of the appliance, and
any corresponding door / panel.
INSTALLATION INSTRUCTIONS