Electrolux ENN2800BOW, User Manual

Page: 11 / 64

Problem Possible cause Solution
The room temperature is
too high. Decrease the room temper-
ature.
Water flows on the
rear plate of the re-
frigerator. During the automatic de-
frosting process, frost de-
frosts on the rear plate. This is correct.
Water flows into the
refrigerator. The water outlet is clog-
ged. Clean the water outlet.
Products prevent that wa-
ter flows into the water
collector. Make sure that products do
not touch the rear plate.
Water flows on the
ground. The melting water outlet
does not flow in the evap-
orative tray above the
compressor. Attach the melting water
outlet to the evaporative
tray.
The temperature in
the appliance is too
low/high. The temperature regulator
is not set correctly. Set a higher/lower tempera-
ture.
The temperature in
the refrigerator is
too high. There is no cold air circu-
lation in the appliance. Make sure that there is cold
air circulation in the appli-
ance.
The temperature in
the freezer is too
high. Products are too near to
each other. Store products so that
there is cold air circulation.
There is too much
frost. Food is not wrapped cor-
rectly. Wrap the food correctly.
The door is not closed
correctly. Refer to "Closing the door".
The temperature regulator
is not set correctly. Set a higher temperature.
6.1 Replacing the lamp
CAUTION!
Disconnect the plug from the
mains socket.
1
1
2
1. At the same time, with the fingers ex-
pand up and down the transparent cov-
er and unhook it in the direction of the
arrows.
2. Replace the lamp with one of the same
power and shape, specifically designed
for household appliances. (the maximum
power is shown on the light bulb cover).
3. Reassemble the lamp cover.
4.
Connect the plug to the mains socket.
5.
Open the door. Make sure that the light
comes on.
ENGLISH 11