10
INSTALLATION
CAUTION!
Do not block the air vents. If you do that, the appliance can
overheat.
CAUTION!
Do not connect the appliance to adapters or extension
leads. This can cause overloading and risk of fire.
•
Put the appliance far away from steam, hot air and
water splashes.
•
If the appliance is stored/ transported at sub-zero
temperatures, do not activate it immediately after
installation. Allow at least two hours for it to be brought
up to room temperature before turning on the unit.
Installation
•
Remove all packing material and any promotional
material from the microwave oven.
•
Examine the oven for any damage such as dents or a
broken door. Do not install if the oven is damaged. Call
the service centre.
• Remove the protective film on the oven cabinet
surface. Do not remove the light brown Mica cover that
is attached to the right-hand side of the oven cavity to
protect the magnatron.
•
Do not leave the packing material so that small
children can play with it. This can be hazardous.
• Select a flat, level surface that provides enough open
space for the intake and outlet vents and that is strong
enough to bear the weight of the oven. A minimum
clearance of 7.5cm is required between the oven and
any adjacent walls. Leave a minimum clearance 30cm
above the oven.
30cm
7.5cm
20cm
20cm
min85cm
Blocking the intake or outlet vents can damage the oven.
If air vents are blocked during operation, the oven may
overheat, and this may lead to malfunctioning. Hot air
escapes from the vents, so be sure not to obstruct it or let
curtains come between the oven and the rear wall.
NOTE: It is recommended to have greater than 7.5cm
clearance on at least one of the sides to improve product
performance and operation.
•
The oven should be placed in a stable position to
avoid the possibility of causing vibration or noise.
•
Do not remove the legs from the bottom of the oven.
•
This oven should only be installed freestanding; not
built-in or in a cabinet.
•
•
Keep the oven away from heat and water. Exposure
to heat and water can lower the efficiency and lead to
malfunctioning.
Place the oven as far away from radios and TV
as possible. Operation of the oven may cause
interference to your radio or TV reception.
•
When there is interference, it may be reduced or
eliminated by taking the following measures:
-
Clean door and sealing surface of the microwave
oven.
-
Reorient the receiving antenna of the radio and/or
television.
-
Move the microwave oven away from the receiver.
-
Plug the microwave oven into a different outlet so
that microwave oven and receiver are on different
branch circuits.
•
Be sure the voltage and frequency where you connect
the microwave oven is the same as specified on the
rating plate on the microwave oven. If the microwave
oven is connected to the socket via an extension cord,
make sure the cord is earthed.
WARNING!
If installed near or over a heat source, the microwave oven
could be damaged.
WARNING!
This microwave oven must not be used on a non-earth
protected power supply. Contact an electrician if you are
uncertain regarding electrical connection of the oven or
provision of earth protection of the supply.
WARNING!
If the power cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
