3. Burner valves must be in the "off" position.
4. Open the LP-Gas cylinder valve.
5. Push in side burner control knob fully and rotate slowly about 1/4 turn
counterclockwise until a click is heard.
6. If ignition does not occur, repeat step 5 in rapid succession for no more than
5 seconds or until burner ignites. If ignition still does not occur, immediately
turn the burner control(s) off, wait 5 minutes for the gas to clear and repeat
the lighting procedure.
7. After burner ignites, adjust control knob to desired cooking setting.
care and cleaning
58
electrolux
57 electrolux
operation instruction
Shutting Off Burners
1. Always turn the valve knob(s) clockwise to the High position, and then push
in and turn to OFF. Never force the knob without depressing it as this can
damage the valve.
2. Promptly turn the gas supply OFF at the propane cylinder.
3. Close the lid of the grill.
Lighting Burner With A Match
1. Place a match in the end of the
match holder that is pre-installed
on the sides of Grill Housing. Once
lit, immediately place the flame
through the hole as shown near the
burner ports.
2. Press in knob and rotate
counterclockwise to High setting
and burner should light
immediately. If more than one
burner is desired, turn other knobs
to “on” positions after first burner
is lit.
3. Adjust burners to desired cooking
settings.
Observe Flame Height When lit: Flame
should be a blue / yellow color
between 1- 2 in. high.
Care and cleaning
All cleaning and maintenance should be done when grill is cool and with the gas
supply turned off at the propane cylinder. DO NOT clean any grill part in a self-
cleaning oven. The extreme heat will damage the finish.
Cleaning
Burning-off the grill after every use (approx. 15 minutes) will keep excessive
food residue from building up. To “Burn Off” or heat clean your grill, turn the 3
main burners to HIGH and run for 15 minutes with the lid closed. Then use a
wire brush to clean the grids.
Recommended cleaning materials
Mild dishwashing liquid detergent, hot water, nylon cleaning pad, wire brush.
DO NOT use cleaners that contain acid, mineral spirits or xylene.
Outside surfaces
Use ONLY mild dishwashing detergent and hot water solution to clean, and
then rinse with water.
If the inside surface of the grill lid has the appearance of peeling paint, baked
on grease buildup has turned to carbon and is flaking off. Clean thoroughly with
strong solution of detergent and hot water.
Rinse with water and allow to completely dry.
Interior of grill bottom
Remove residue using brush, scraper and/or cleaning pad, and then wash with
dishwashing detergent and hot water solution. Rinse with water and let
thoroughly dry.
Cooking Grids
The porcelain grates have a glass-like composition that should be handled with
care not to chip. Use mild dishwashing detergent or baking soda and hot water
solution.
Nonabrasive scouring powder can be used on stubborn stains, and then rinse
with water.
Heat Shield
Clean residue with wire brush and wash with soapy water. Then rinse with
water.
Blue
Blue
Light blue
Yellow
Good
Bad
Light blue
Yellow
E
N
G
E
N
G
