Electrolux EKM 6035, Instruction Booklet, Page: 27 / 37

electrolux 27
If the appliance is not working correctly, please carry out the following checks,
before contacting your local Service Centre.
IMPORTANT: If you call out an engineer to a fault listed below, or to repair a
fault caused by incorrect use or installation, a charge will be made even if the
appliance is under guarantee.
SYMPTOM
! !!
!
!
There is no spark when
lighting the gas.
! !! ! !
The gas ring burns
unevenly.
! !! ! !
The oven does not come
on.
! !! ! !
The oven light does not
come on.
! !! ! !
It takes too long to finish
the dishes, or they are
cooked too fast.
! !!
!
!
Steam and condensation
settle on the food and the
oven cavity.
! !!
! !
The oven fan is noisy.
! !!
! !
The display shows
"12.00".
SOLUTION
" "
" "
"
Check that the unit is plugged in and the
electrical supply is switched on
" "
" "
"
Check the mains fuse has not blown
" " " " "
Check the burner cap and crown have been
replaced correctly, e.g. after cleaning.
" " " " "
Check the main jet is not blocked and the burner
crown is clear of food particles.
" " " " "
Check the burner cap and crown have been
replaced correctly, e.g. after cleaning.
" " " " "
Check that a cooking function has been
selected.
" " " " "
Check that the time of day has ben set (see
chapter "How to set the time of day").
" "
" "
"
Check that the socket switch or the switch from
the mains supply to the appliance are ON.
" " " " "
Select a function with the oven function control
knob.
" " " " "
Check the light bulb, and replace it if necessary
(see "Oven lamp replacement").
" "
" " "
The temperature may need adjusting.
" "
" "
"
Refer to the contents of this booklet, especially to
the chapter “Using the Oven”.
" "
" " "
Leave dishes inside the oven no longer than 15-
20 minutes after the cooking is completed.
" "
" " "
Check that shelves and bakeware are not
vibrating in contact with the oven back panel.
" " " " "
Set the time of day (see chapter "How to set the
time of day").
If after all these checks, the appliance still does not work, contact your local
Service Force Centre.
Something not working