ENGLISH 21
5.4
Electrical connection
The electrical connection must be
carried out in accordance with the
current standards and laws in force.
Before connecting check that:
• the system and electrical sockets
amperage is adequate for the
appliance maximum power (see
data label affixed on the back of the
cooker).
• the socket or system has an effective
earth connection in accordance with
current standards and prescriptions of
the law. All responsibility is disclaimed
if this is not complied with.
• the plug and socket or the multipolar
switch must be accessible after
installation of the appliance.
When connecting to the mains with a
socket:
• Fit to the power cable (if without) a
standardized plug, suitable for the
load which is indicated on the data
label. Connect the wires making sure
they correspond as shown below, and
remember that the earth wire must
be longer than the phase wires:
letter
L (phase) = brown wire
letter
N (neutral) = blue wire
symbol
(earth) = green/yellow wire
• The power cable must be laid so that
no parts of it ever reach a temperature
of 75 °C.
• For connecting do not use, adapters
or shunts as they could cause false
contacts resulting in hazardous
overheating.
When connecting directly to the
mains:
• Install a multipolar switch that can
withstand the appliance load, with
a minimum opening between the
contacts of 3 mm. Remember that the
earth wire must not be cut out by the
switch.
Connecting the power cable
The all-electric cookers and some combi
versions are without supply cable and are
adjusted for single-phase power, butt they
can, with due modifications, be powered
by three phase systems by following these
instructions:
• Remove the rear panel from the
cooker.
• Move the connecting plates in the
terminal board fig.7, following the
diagram in fig. 8.
• You will also find this diagram affixed
to the back of the cooker.(fig.9)
according to the type of connection
you want.
• Connect the power cable, whose
cross section must be suitable (see
paragraph «TECHNICAL FEATURES»),
keeping the earth wire longer than the
phase wires.
• Secure the cable in the clamp and - fit
the rear panel in place.
fig.7
fig. 8
fig. 9
