14 www.electrolux.com
Ud
Bd
S
G
Fig. 10
Replacing the oven lamp (fig.11)
Ensure the appliance is switched off
before replacing the lamp to avoid the
possibility of electric shock..
In the event one or both oven lamps need
replacing, the new lamps must comply
with the following requisites: 15 W -
230 V~ - 50 Hz - E 14 - and must be
resistant to high temperature (300°C).
Turn glass protection cap
2
counterclockwise and change the lamp.
Re-fit the cap, screwing it back in a
clockwise direction.
QM
M
Q
T
T
M
QM
M
Q
T
T
M
E
W
1
2
Fig. 11
Oven seal
The oven seal guarantees the correct
functioning of the oven. We recommend
you:
• clean it, avoiding abrasive tools or
products.
• check its state now and then.
If the oven door seal has become hard
or is damaged, contact our Service
Centre and avoid using the oven until
it has been repaired.
Self-cleaning panels
Oven walls are protected by panels coated
with a grease-proof, microporous enamel
that absorbs and eliminates splattering
during baking.
If there is a lot of liquid or grease, dry
immediately with a damp sponge and heat
the oven for 2 hours on the maximum
thermostat position. Wait for the oven to
cool down and then go over it again with a
damp sponge. If you are unable to remove
all the substances, repeat the above
procedure.
It is, however, advisable to periodically
remove the panels and wash them with
warm soapy water and dry them with a
soft cloth.
To remove them follow these instructions:
• Extract the side grids as indicated in
the previous paragraph.
• Remove both side panels
1
(fig.12).
• Remove back panel by unscrewing
respective locking screws
6
(fig. 13).
• Repeat previous operations in reverse
order to replace all elements.
Important!
Position both side
panels
1
by taking the locking pin
2
out of the hole
3
(fig. 12).
