Electrolux EIV85443, User Manual

Page: 22 / 28

Problem Possible cause Remedy
You do not set the heat
setting for 10 seconds.
Activate the hob again and
set the heat setting in less
than 10 seconds.
You touched 2 or more
sensor fields at the same
time.
Touch only one sensor
field.
There is water or fat stains
on the control panel.
Clean the control panel.
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactiva‐
ted.
You put something on one
or more sensor fields.
Remove the object from
the sensor fields.
The hob deactivates. You put something on the
sensor field . Remove the object from
the sensor field.
Residual heat indicator
does not come on.
The zone is not hot be‐
cause it operated only for a
short time or the sensor is
damaged.
If the zone operated suffi‐
ciently long to be hot,
speak to an Authorised
Service Centre.
Hob²Hood does not work. You covered the control
panel.
Remove the object from
the control panel.
You use a very tall pot
which blocks the signal.
Use a smaller pot, change
the cooking zone or oper‐
ate the hood manually.
Automatic Heat Up does
not operate.
The zone is hot. Let the zone become suffi‐
ciently cool.
The highest heat setting is
set.
The highest heat setting
has the same power as the
function.
The heat setting changes
between two levels.
Power management oper‐
ates.
Refer to "Daily use".
The sensor fields become
hot.
The cookware is too large
or you put it too near to the
controls.
Put large cookware on the
rear zones, if possible.
There is no sound when
you touch the panel sensor
fields.
The sounds are deactiva‐
ted.
Activate the sounds. Refer
to "Daily use".
www.electrolux.com 22