![Electrolux EHTA060 Installation And Operating Manual Download Page 25](http://html.mh-extra.com/html/electrolux/ehta060/ehta060_installation-and-operating-manual_92033025.webp)
25
–
Cycle 2
–
Cycle 3
• To stop the wash cycle, just press the selected cycle button
or lift the hood.
• To continue the wash cycle, just press the selected cycle
button or close the hood. The cycle starts again from where
it stopped.
• At the end of the wash, the dishwasher emits a series of
beeps and “END“ blinks on the display:
NOTE!
For wash cycle 3, there will be 1 minute final
pause at the end of the cycle to improve the
drying result and be compliant with “A
0
60“ level.
• Lift the hood and remove the rack containing the clean
dishes.
IMPORTANT
Change the water in the tank at least twice a day.
•
Delime cycle (if enabled)
Press this button to run a machine water circuit delime cycle
with vinegar.
It is advisable to run this cycle according to that given in the
table:
Water hardness
The Delime
cycle should
be run approx-
imately every:
1
Using cycle 2
for 30 cycles/
day, the Delime
cycle should
be run approx-
imately every:
°f
°d
°e
Cycles
Days
5
2.8
3.5
1500
50
10
5.6
7.0
750
25
15
8.4
10.5
510
17
20
11.2
14
380
13
25
14
17.5
300
10
30
16.8
21.1
250
8
1.
Considering a rinse time according to the factory settings.
Proceed as follows:
• Insert the Delime hose present in the machine, identified by
an appropriate label, in a container with at least 2l of wine
vinegar 6% (2l is the minimum amount of vinegar needed
for a correct Delime cycle).
CAUTION
Only use wine vinegar (with 6% of
acetic acid) and not other descaling
substances.
WARNING
Descaling with the use of
chemical
substances
other
than vinegar must only be
done
by
a
specialised
personnel.
• Remove the basket with dishes and remove the overflow “2“
(refer to G
). Close the hood. Activate the
delime cycle by pressing the delime button for at least 5
seconds.
IMPORTANT
The delime cycle lasts about 1h 30sec; during
this phase the hood must not be opened and no
other command can be activated until comple-
tion of the cycle in progress. If the machine is
turned off during the delime cycle, at the next
restart the cycle will resume exactly from where it
was interrupted, until its completion.
• At the end of Delime cycle, the dishwasher sounds a series
of beeps and “END“ will flash on the display.
Refit the previously removed overflow.
CAUTION
• Remove large food scraps from the
dishes to prevent clogging the filters.
• The appliance will not remove burnt
food deposits from dishes. Dishes with
burnt-on food deposits should be
cleaned mechanically/chemically (for
example,
pre-wash
under
running
water) before putting them in the
dishwasher.
• Failure to remove the residuals of
detergent possibly used for manual
prewash can cause malfunctioning of
the dishwasher and compromise wash-
ing results.
• The use of “foaming“ or non-specific
detergents or in any case detergents
used in different ways from that pre-
scribed by the manufacturer, can cause
damage to the dishwasher and com-
promise washing results.
J.6
Type of racks and loading
• GREEN rack: for 12 bowls with maximum diameter of 240
mm.
• BLUE rack for glasses: the glasses should be placed upside
down.