Electrolux EHT7830, User Manual

Page: 9 / 16

3. Adjust the flame after it is regular.
If after some tries the burner does not
light, check if the crown and its cap are
in correct positions.
3
4
2
1
1
2
3
4
1
Burner cap
2
Burner crown
3
Ignition candle
4
Thermocouple
Warning! Do not keep the control
knob pushed for more than 15
seconds.
If the burner does not light after 15
seconds, release the control knob, turn
it into off position and try to light the
burner again after minimum 1 minute.
Important! In the absence of electricity you
can ignite the burner without electrical
device; in this case approach the burner
with a flame, push the relevant knob down
and turn it counter-clockwise to maximum
gas release position.
If the burner accidentally goes out, turn
the control knob to the off position and
try to light the burner again after mini-
mum 1 minute.
The spark generator can start automat-
ically when you switch on the mains,
after installation or a power cut. It is
normal.
TURNING THE BURNER OFF
To put the flame out, turn the knob to the
symbol
.
Warning! Always turn the flame down
or switch it off before you remove the
pans of the burner.
HELPFUL HINTS AND TIPS
ENERGY SAVINGS
• If possible, always put the lids on the
pans.
• When the liquid starts to boil, turn down
the flame to barely simmer the liquid.
Warning! Use pots and pans with
diameter applicable to the dimension of
burner.
Do not use cooking vessels on the hot-
plate that overlap its edges.
Burner Diameters of cookware
Triple Crown 180 - 260 mm
Burner Diameters of cookware
Semi-rapid
(rear left)
120 - 220 mm
Semi-rapid
(rear right)
120 - 220 mm
Semi-rapid
(front right)
120 - 180 mm
Auxiliary 80 - 180 mm
Warning! Pots must not enter the
control zone.
electrolux 9