17
Cooking with the automatic warm-up
function
All four cooking zones of the hob can be controlled
in nine stages and have an automatic warm-up
function:
•
, lowest heat setting
•
, highest heat setting
•
, warm-up function
When you select the required heat setting with the
heat setting selection sensor field
, the cooking
zone will work for a specific time on full power and
will then switch automatically to the heat setting
selected.
The duration of the automatic warm-up function
depends on the heat setting selected.
Touch the sensor field heat setting selection
in
order to set the required heat setting
to
.
The heat setting selected is shown first.
After 5 seconds, the heat setting will be replaced
by
(= automatic warm-up function) in the
display. After the end of the warm-up time, the heat
setting will be shown again.
If during the automatic warm-up function
you select a higher setting, e.g., from
to
, the warm-up time is adjusted to
match.
If you select a lower setting, the warm-up
time ends immediately.
Cooking with the automatic warm-up
function is only possible with a cold or
moderately warm cooking zone. If a
cooking zone is already hot when
switched on (display
), you cannot
work with the automatic warm-up
function.
Summary of Contents for EHS 6651 P
