Electrolux EHG 6762, Instruction Booklet

Page: 18 / 32

18 electrolux
600 MIN.
Location Location
Location Location Location
The hob may be located in a kitchen, a
kitchen/diner or bed sitting room, but not
in a bathroom, shower room or garage.
Ensure that there is a minimum distance
of 55 mm between the rear cut out edge
and the wall.
A minimum distance of 100 mm must be
left between the side edges of the cut out
and any adjacent cabinets or walls.
The minimum distance combustible
material can be fitted above the hob in
line with the edges of the hob is 400 mm.
If it is fitted below 400 mm a space of 50
mm must be allowed from the edges of
the hob.
The minimum distance combustible
material or a cooker hood can be fitted
above the hob is 650 mm.
For appliances installed in the Republic
of Ireland please refer to NSAI- Domestic
Gas Installation I.S 813 Current Edition
Section 7- Permitted Locations of
Appliance.
It is important to install the elbow corr It is important to install the elbow corr
It is important to install the elbow corr It is important to install the elbow corr
It is important to install the elbow correctly ectly
ectly ectly
ectly, with the shoulder on , with the shoulder on
, with the shoulder on , with the shoulder on
, with the shoulder on
the end of the thread, fitted to the hob connecting pipe. the end of the thread, fitted to the hob connecting pipe.
the end of the thread, fitted to the hob connecting pipe. the end of the thread, fitted to the hob connecting pipe.
the end of the thread, fitted to the hob connecting pipe.
Failure to ensure the correct assembly will cause leakage of gas. Failure to ensure the correct assembly will cause leakage of gas. Failure to ensure the correct assembly will cause leakage of gas. Failure to ensure the correct assembly will cause leakage of gas. Failure to ensure the correct assembly will cause leakage of gas.
Gas Connection Gas Connection
Gas Connection Gas Connection
Gas Connection
Connection to the gas supply should be with either rigid or semi-rigid pipe, i.e. steel
or copper.
The connection should be suitable for connecting to R 1/2 (1/2 BSP male thread).
When the final connection has been made, it is essential that a thorough leak test is
carried out on the hob and installation.
Ensure that the main connection pipe does not exert any strain on the hob.