Electrolux EHD6690X, Installation And Operating Instructions Manual

Page: 15 / 32

15
3.
Next, touch the sensor field
-
and set the required
continued heat setting
1
to
8
. The heat setting se-
lected for further cooking then is displayed.
After 5 seconds,
a
appears in the display again in-
stead of heat setting selected for further cooking.
The heat setting is displayed again after the heating-
up time has ended.
3
If you select a higher heat setting when the au-
tomatic function is in operation, e.g. from
3
to
5
, the previous heating-up time is taken into
account. If you select a lower setting, then the
automatic function is brought to an immediate
end. If you start cooking again on a cooking
zone that is still warm, the automatic heating-
up function uses the residual heat. This saves
time and energy.
Cooking without the Automatic
Heating-Up Function
1. For heating up/browning, select a high power.
2.
As soon as steam forms or the fat is hot, switch
back to the required heat setting for the remainder
of the cooking time.
3. Reset to zero in order to end cooking.
2
Note:
When cooking with the induction cooking
zone you should take into account that
– the heating-up times are reduced by the direct en-
ergy transfer to the pan!
– the cooking process stops immediately after the
cooking zone is switched off (no boiling over!)
Locking/Unlocking the Control
Panel
With the exception of the “On/Off” sensor field the
control panel can be locked at any required time dur-
ing cooking in order to prevent adjusting the settings
such as when wiping over with a cloth. This
function is also suitable as a child safety feature.
1.
Touch the „lock“ sensor field until the control indi-
cator comes on.
2. To release the lock touch the „lock“ sensor field
again continuously until the control indicator goes
out.
3
Child safety feature! If the hob is completely
switched off using the “On/Off” sensor field
while the lock is on, then the lock will still be
active when the hob is switched on again. To
reactivate the cooking zones, the locking func-
tion must be cancelled as described above.