Electrolux EGG6041, User Manual

Page: 6 / 16

Always light the burner before you
put cookware on it.
To light the burner:
1. Push and hold the spark generator
button
.
2.
At the same time turn the knob coun-
terclockwise to the maximum position
and push it down to light the burn-
er.
3.
Release the spark generator button
when the burner lights but keep the
knob on this position for approxi-
mately 5 seconds; this will let the
thermocouple warm up. If not, the
gas supply will be interrupted.
4. Adjust the flame after it is regular.
If after some tries the burner does
not light, check if the crown and
its cap are in the correct positions.
A
B
C
D
A) Burner cap
B) Burner crown
C)
Ignition candle
D) Thermocouple
WARNING!
Do not keep the control knob
pushed for more than 15 sec-
onds.
If the burner does not light after
15 seconds, release the control
knob, turn it into off position and
try to light the burner again after
minimum 1 minute.
In the absence of electricity you
can ignite the burner without elec-
trical device; in this case approach
the burner with a flame, push the
relevant knob down and turn it
counter-clockwise to maximum
gas release position.
If the burner accidentally goes out,
turn the control knob to the off
position and try to light the burner
again after minimum 1 minute.
The spark generator can start au-
tomatically when you switch on
the mains, after installation or a
power cut. It is normal.
3.2 Turning the burner off
To put the flame out, turn the knob to the
symbol
.
WARNING!
Always turn the flame down or
switch it off before you remove the
pans from the burner.
4. HELPFUL HINTS AND TIPS
WARNING!
Refer to "Safety information"
chapter.
4.1 Energy savings
• If possible, always put the lids on the
pans.
• When the liquid starts to boil, turn down
the flame to barely simmer the liquid.
Use cookware with diameters applicable
to the size of burners.
Burner Diameters of cook-
ware
Rapid 180 - 260 mm
Semi-rapid 120 - 220 mm
Auxiliary 80 - 180 mm
6
www.electrolux.com