39
Installation between two cabinets
The locking screws must be in place (x 2).
If this is not the case, the hood could drop.
If the hood is to be installed in such a way that the
top edge of the front panel is aligned with the base
of the cabinet (see figure 1), follow the instructions
provided for "Installing the hood in a cabinet" with
16 mm walls, points 3-8.
If the hood is to be installed at a height above that
of the cabinet base:
1.
Use the installation template to trace two
vertical lines on either side (see figure 2).
2.
Measure the height at which the hood must be
installed.
3.
Install the suspension bars (see figure 3).
The drawing illustrates the left-hand side. The
right-hand side is the exact opposite.
4.
Raise the hood and insert the hooks in the
special slots.
5.
Push the hood against the wall. Check that all
the hooks are correctly inserted in the slots.
6.
Install the locking screw (see "Installing the
hood in a cabinet", figure 4).
Electrical connection
The electricity socket must be situated above the
hood, inside a wall cabinet. The hood is supplied
with an electrical power supply cable fitted with a
moulded plug with an earthing pin, suitable for a
230 V wall socket.
Depth adjustment
Once the hood has been installed, adjust it so that
it is in line with the wall.
1.
Remove the filter as illustrated in the chapter
entitled "Care and cleaning".
2.
Unscrew the screws (see figure).
3.
Push the adjustment arms against the wall.
4.
Tighten the screws.
5.
Reposition the grease filter.
-
1.
2.
3.
1
2
