The freestanding type installation requires four screw-in feet to be
installed before it can be fitted in between cabinets, with cabinets
on one side or without adjacent cabinets. There is no clearance
requirement to adjacent side cabinets.
To ensure cooker stability, the anti-tilt brackets must be installed.
Four screw-in feet are supplied with the appliance and can be found
in the accessories pack in the oven. Select models are supplied with a
clip-on kick panel.
900mm minimum
755mm NOM
900mm NOM
600mm both
sides
Installation of feet
• Freestanding appliances are supplied with four screw-in feet in
the internal accessory pack. The screw-in feet can be adjusted by
turning the lower half clockwise or anti-clockwise.
TIPS & INFORMATION
IMPORTANT
• If the appliance is a gas hob model, remove the burner cap
and burner crown. Store all items safely, away from the
installation area.
1. You MUST remove the oven door and accessory pack before
commencing installation.
Locking tab up at
normal position
Press the locking tab down for
removing the door.
Locking tab up at normal position.
Press the locking tab down for
removing the door.
Gently close the door until it comes to
a stop.Then lift the door off the hinge.
Locking tab up at normal position.
Press the locking tab down for
removing the door.
Gently close the door until it comes to
a stop.Then lift the door off the hinge.
2. Gently close the door until it comes to a stop.
Then lift the door off the hinge.
3. Tilt and carefully lay the appliance on its back to gain access to
the installation point for the screw in feet.
CAUTION
• To avoid scratching the floor and the appliance itself, fold the
packaging carton board and place it underneath the appliance
as protection.
• The cooker MUST be laid on its back when installing the feet.
4. Install the four supplied feet via the four installation points. Make
sure that each foot is securely fastened. Do not over torque the
foot.
Put the oven door handle protection
foam underneath the laid down
cooker to protect your cooker when
putting it upright
5. Adjust the height of the screw-in feet to make sure the hob surface
is 10mm above the bench when appliance is upright.
Bench 10mm minimum
6. Tilt the appliance upright by lifting the back of the hob and
pivoting it about the back two feet.
WARNING
Heavy item! This step must be performed by two persons.
Freestanding installation
2
Installation guide
90cm freestanding cookers
