37
Charcoal filter
The charcoal filter should only be used if you
want to use the hood in the recirculation
function.
To do this you will need an original charcoal
filter (available from your local Service Force
Centre).
Cleaning/replacing the charcoal filter
Unlike other carbon filters, the LONGLIFE
carbon filter can be cleaned and reactivated. At
normal use the filter should be cleaned every
second month (when using the hood 2,5 hours per
day, in avarage). The best way to clean the filter is
in the dishwasher. Use normal detergent and
choose the highest temperature (65º C). Wash the
filter separately so that no food parts gets stuck on
the filter and later causes bad odours. To
reactivate the charcoal, the filter should be dried in
an oven for 10 minutes with a temperature of
maximum 100º C.
After approximately three years of use, the
charcoal filter should be replaced with a new, as
the odour reduction capacity will be reduced.
Fitting - Fig. 4
Remove the frame
i
which supports the filter
h
by turning 90° the two knobs
g.
Insert the charcoal filter inside the frame and
put all parts back in their place.
To remove
proceed in the reverse order.
Always specify the hood model code number
and serial number when ordering replacement
filters. This information is shown on the
registration plate located on the inside of the
unit.
The charcoal filter can be ordered from your
local Service Force Centre.
Fig. 4
i
g
h
g
g
g
Changing the light bulb
Disconnect the cooker hood from the
mains supply.
Remove the lamp cover carefully, use a screw
driver as a lever.
Fig. 5.
Replace the old bulb with a new one of the
same type.
Refit the lamp cover.
If the light does not come on, make sure the
bulb has been inserted in correctly before
contacting your local Service Force Centre.
Fig. 5
