18
Changing bulb for inside light
Only use a special bulb which is designed specially
for dryers. The special bulb is available from the af-
ter-sales service, ET-Nr. 112 552 000-5.
1
Warning!
Do not use standard bulbs! These
develop too much heat and may damage the
machine!
1
Warning!
Before replacing the bulb, discon-
nect the mains plug; with a permanent con-
nection: fully unscrew or deactivate the fuse.
1.
Unscrew covering bonnet from above bulb (this
can be found directly behind the loading aperture,
at the top; refer to “Description of machine” sec-
tion.)
2.
Replace defective bulb.
3.
Screw covering bonnet back down.
1
Warning!
For reasons associated with safety,
the covering bonnet must be screwed down
tightly. If this is not done, the dryer must not
be operated.
Loading door does not close.
Fine strainer not in place and/or
large mesh filter not locked in place.
Install fine strainer and/or snap large
mesh filter into place.
When a button is pressed,
Err
appears in the multi-dis-
play.
Washing protection. After the start of
the programme, the option can no
longer be set.
Turn the programme knob to OFF
(AUS). Set the programme again.
Drum light does not work.
Programme selector in OFF (AUS)
position.
Turn programme selector to LIGHT (BE-
LEUCHTUNG) or to any programme.
Defective light bulb.
Replace light bulb (see next section).
PROGRAMME TIME
(LAUFZEIT) display changes
erratically or stays unchanged
for a long time.
Programme time is corrected auto-
matically depending on type and
volume of laundry and level of
dampness.
Automatic process; this is not a ma-
chine fault.
Programme inactive, EMPTY
WATER (BEHÄLTER) display
illuminated.
Condensate tank is full.
Empty condensate tank, then start pro-
gramme with START/PAUSE button.
Drying cycle ends shortly after
programme starts. END
(ENDE) display illuminated.
Not enough washing loaded or
washing loaded is too dry for select-
ed programme.
Select time programme or higher drying
level (e.g. INTENSIVE DRY [STARK-
TROCKEN] instead of STORAGE DRY
[SCHRANKTROCKEN]).
Drying cycle lasts an unusual-
ly long time.
Note:
After around 5 hours the dry-
ing cycle ends automatically
(see „Drying cycle complete“).
Lint filter clogged.
Clean lint filter.
Heat exchanger clogged with lint.
Clean heat exchanger.
SPECIAL CARE (SCHON) button
pressed and load volume too big.
SPECIAL CARE (SCHON) is only suita-
ble for use with loads of up to 3kg!
Load volume too big.
Reduce load volume.
Laundry insufficiently pre-drained.
Laundry must be adequately pre-
drained.
Problem
Possible cause
Remedy
