7
ENGLISH
4.1
Controls after transport
After removing the packaging, make sure
the product is complete and undamaged
and that all accessories are present.Do
not use the appliance if it is visibly dam-
aged. Contact Customer Services.
4.2
Installing the appliance
IMPORTANT!
• Installation must be performed by a
qualified professional in compliance
with legislation in force in the country
of installation (see Built-in installation).
• The packing elements (plastic bags,
polystyrene foam, etc.) should be kept
out of reach of children.
• Do not install the appliance in rooms
where the temperature may drop to
0°C or lower.
• Customise the water hardness as soon
as possible following the instructions in
the “Setting water hardness” section.
4.
PRELIMINARY CHECKS
Coffee has been used to factory test the
appliance and it is therefore completely
normal for there to be traces of coffee in
the mill.
Customise water hardness as
soon as possible following the
instructions in the “17.7 Setting
water hardness” section.
1.
Connect the appliance to the mains
supply. Press the ON/stand-by button
(A7) (fig. 7).
Set the required language.
2.
To set the language, use the
icons (B7 and B8) to choose the
required language (fig. 2). When the
message “PRESS OK TO CHOOSE
ENGLISH” is displayed, press the OK
icon (B9) (fig. 3) for 3 seconds until
“ENGLISH INSTALLED” is displayed.
If you set the wrong language, follow
the instructions in the “Setting the
language” section. If your language is
not available, select one from those
displayed. The instructions refer to
the English version. Then follow the
instructions displayed:
3.
After 5 seconds, the appliance dis-
plays “FILL TANK”. Extract the water
tank (fig. 4), rinse and fill with fresh
water.
Replace and push as far as it will go.
4.
Place a cup under the hot water
spout (fig. 5). (If the hot water spout
is not inserted, the appliance displays
“INSERT WATER SPOUT”. Attach it
as shown in figure 6.
The appliance displays: “HOT WA-
TER PRESS OK”.
Press the OK icon (B9) (fig. 6) and
after a few seconds a little water
comes out of the spout.
5.
The machine now displays “TURN-
ING OFF... PLEASE WAIT” and goes
off.
6.
Extract the appliance by pulling it out
using the handles (fig. 9). Open the
lid and fill the container with coffee
beans, then close the lid and push
the appliance in.
The coffee maker is now ready for
normal use.
IMPORTANT!
Never introduce pre-ground cof-
fee, freeze dried coffee, caramel-
ised beans or anything else which
could damage the appliance.
When using the appliance for the
first time, you need to make 4-5
cups of coffee and 4-5 cappuc-
cinos before the appliance gives
satisfactory results.
Each time you turn the coffee
maker on by the ON/OFF main
switch (A23), it performs a SELF-
DIAGNOSIS cycle and then goes
off. To turn it on again, press the
ON/stand-by button (A7) (fig. 7).
5.
USING THE APPLIANCE FOR THE FIRST TIME
