electrolux e:line rangehood
maintenance and cleaning/changing the halogen lamps 5
caution
•
Before maintenance or cleaning is carried out,
the canopy rangehood should be disconnected
from the main power supply. Ensure that the
rangehood is switched off at the wall socket
and the plug removed.
•
External surfaces are susceptible to scratches and
abrasions, so please follow the instructions below
to ensure the best possible result is achieved
without damage.
Stainless Steel Surface
Clean stainless steel surfaces using non-abrasive cleaning
products that are specifically for use on stainless steel.
To ensure best results also use an even pressure and follow
the grain of the stainless steel. Use of a soft cloth reduces
the risk of scratching. If the cloth is wet ensure that a dry
soft cloth is used to wipe down the surface again reducing
the risk of any surface rust appearing.
Glass Surface
The inlay glass panel can be cleaned using warm soapy
water. Ensure the cloth is well wrung before cleaning. Use
a dry soft cloth to remove any excess moisture left after
cleaning.
Cleaning grease filters
The mesh filters can be cleaned either by hand or in
the dishwasher. After cleaning ensure that the filters are
completely dry before refitting.
By hand: Soak in warm water and some washing up liquid.
For stubborn grease stains use a soft nylon brush to help
remove these stains.
In a dishwasher: Ensure that placement of filters is made so
as to no impede the functioning of the spray arm. Washing
the filters in a dishwasher may cause discolouration of the
filters although it will not affect their performance.
Using a small flat blade screwdriver remove the inner
stainless steel ring to obtain access to the halogen globe.
When removing the inner ring, do so carefully, as the glass
lens could easily fall out of the inner ring. Remove halogen
globe, whilst cool, and replace carefully with a new globe.
The rangehood takes 2 x 20W, 12 volt halogen globes.
important
When handling globes hold with a cloth or gloves to ensure
perspiration does not come in contact with the globe as this
can reduce the life of the globe.
Maintenance and cleaning
Changing the halogen lamps
