EN
1
16
INSTALLATION
Drilling the Support surface and Fitting the Hood
• The Hood can be fitted directly on the
lower surface of the Wall Units (650 mm
min. above the Cooker Top) using the snap-
on Side Supports.
• Make an opening on the lower surface of
the Wall Unit, as indicated. (fig.1)
• If the cabinet is without bottom, fix the two
brackets at a distance
B
of minimum 30mm
and maximum 60mm. (fig.2)
• Before carrying out the installation, the
wooden transportation protections screwed
on the visor and on the canopy body must
be removed. (fig.3)
• Choose the correct flange measure basing
on the air outlet diameter and insert it to the
upper air outlet opening. (fig.4)
• Screw the closing profile
20
onto the rear
part of the hood, using the screws
12f
(2.9
x 9.5) provided. (fig.5)
• Open the sliding suction panel.
• Remove the metal grease filters one by one
by turning the hooks provided.
• Close the sliding suction panel again.
• Insert the Hood until the snap-on side sup-
ports click into place. (fig.6)
• Open the sliding suction panel.
• Lock in position by tightening the screws
Vf
from underneath the Hood. (fig.6)
• If necessary, adjust the whole filter holder
unit and proceed as follows:
• Loosen the four adjustment screws
Vr
and close the sliding panel again. (fig.7)
• Move the entire filter holder unit until it
is properly aligned with the wall unit.
(fig.8)
• Keeping the hood canopy still, remove
the sliding panel and lock the adjustment
screws again. (fig.7)
• The hood can now be fastened to the
wall unit using the four screws
12a
(3.5
x 16) provided. (fig.9)
• Replace the metal grease filters.
• Close the sliding suction panel again.
523
162
1
2
3
9
10a
10a
10b
4
6
Vr
7
8
12a
9
5
