Problem
Possible cause
Remedy
The oven does not heat up.
The fuse is blown.
Make sure that the fuse is
the cause of the malfunction.
If the fuse problem recurs,
contact a qualified electri-
cian.
The oven does not work.
The automatic ignition does
not work.
Light the burner with a long
match. Hold the flame near
the hole in the bottom of the
oven cavity. At the same
time push the knob for the
gas control and turn it coun-
terclockwise to the maxi-
mum temperature. When
the flame lights, keep the
knob for the gas control
pushed for 15 seconds or
less to warm up the thermo-
couple. Otherwise the gas
flow is interrupted.
The lamp does not work.
The lamp is broken.
Replace the lamp.
Steam and condensation
settle on the food and in the
oven cavity.
A dish was left in the oven
for too long.
Food should not be left in
the oven for longer than
15-20 minutes after cooking.
The flame extinguishes im-
mediately after ignition.
The thermocouple is not
heated up.
After the flame lights, keep
the knob for the gas control
pushed for 15 seconds or
less.
The turnspit does not rotate. The turnspit is not correctly
installed into the turnspit
hole.
Refer to "Using the accesso-
ries" chapter, Using the turn-
spit.
11.2
Service data
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
The necessary data for the service centre
is on the rating plate. The rating plate is
on the front frame of the oven cavity. Do
not remove the rating plate from the
oven cavity.
We recommend that you write the data here:
Model (MOD.)
.........................................
Product number (PNC)
.........................................
Serial number (S.N.)
.........................................
ENGLISH
17
