Operation
Before using for the first time
Before using the oven, the language, then the display contrast, brightness and the current
time must be set first.
When turning the oven on for the first time, " SET LANGUAGE" will appear on the display
after a few seconds.
1. Use the turning knob to select the desired setting
2. Then press the OK button to confirm your selection.
Select the additional required settings in the same way.
Calibration Adjusting to suit the environment
For optimal results using "Auto-Kochen" the oven must be adjusted to suit the surroundings.
This process is called Kalibrierung and takes approximately 4 hours.
The oven does not need to be calibrated if you only want to use it for conventional cooking.
Please take note of the following points prior to Kalibrierung
•
The Kalibrierung must take place at a room temperature below 35°C
.
• For Kalibrierung, install the oven into its
final location
.
• For the Kalibrierung, connect the oven to the mains supply that will always be used.
• The grease filter must be removed before Kalibrierung.
• The supplied shelf runners must be mounted. (see instructions in the chapter "Cleaning
and Care")
• If the oven location, electrical connection or other above mentioned aspect is changed,
the oven must always be recalibrated so that the function "Auto-Kochen" delivers op
-
timal results.
You will find calibration in the "Einstellungen", "Kalibrierung" menu.
After calibration, the appliance is ready for use as soon as it has cooled down.
Initial cleaning
The oven should be thoroughly cleaned prior to first use. Also wipe out all parts and the
interior with a solution of water and washing-up liquid.
Do not use sharp or abrasive cleaning agents. These could damage the surface.
Switching on and off
– Press the ON/OFF button.
If the oven has been switched off, the time of day is shown. If the oven is still hot, a bar
appears in the display and shows the residual heat remaining in the oven.
Auto cooking
1. Switch the oven on.
2. Select the main category you want by using the sensor buttons.
12
Operation
