5. To memorize the operation, switch off the
dishwasher by pressing the on/off button.
If you decide to revert back to the
use of individual detergents we ad-
vise that you:
1. Deactivate the multitab function.
2. Fill up the salt container and the rinse
aid dispenser again.
3. Adjust the water hardness setting to
the highest setting and perform 1
normal washing programme without
loading any dishes.
4. Adjust the water hardness setting
according to the hardness of the wa-
ter in your area.
5. Adjust the rinse aid dosage.
Select and start a washing programme
Select the washing programme and
delay start with the door slightly
opened. The start of the programme
or the countdown of the delay start
will occur only after the closure of
the door. Until then it is possible to
modify the settings
1. Check that the baskets have been loaded
correctly and that the spray arms are free
to rotate.
2. Check that the water tap is opened.
3. Press the on/off button. The dishwasher
must be in setting mode.
4. Press the button corresponding to the re-
quired programme (refer to 'Washing
programmes' chart).
Close the appliance door, the pro-
gramme starts automatically.
Setting and starting the programme with
delay start
1. After having selected the washing pro-
gramme, press the delay start button until
the flashing number of hours for the delay
start shows in the digital display.
– The delay start indicator light comes
on.
2. Close the appliance door, the countdown
starts automatically.
3. The countdown will decrease with steps
of 1 hour.
4. The opening of the door will interrupt the
countdown. Close the door, the count-
down will continue from the point at
which it was interrupted.
5. Once the delay start has elapsed the pro-
gramme will start automatically.
– The delay start indicator light goes off.
Warning!
Interrupt or cancel a
washing programme in progress
ONLY if it's absolutely necessary.
Attention! Hot steam may escape
when the door is opened. Open the
door carefully.
Interrupt a washing programme in
progress
• Open the dishwasher door; the pro-
gramme will stop. Close the door; the pro-
gramme will start from the point at which
it was interrupted.
Cancel a delay start or a washing
programme in progress
• Simultaneously press and hold the two
function buttons B and C until all the pro-
gramme lights come on.
• Cancelling a delay start will also cancel the
washing programme. You have to select
the washing programme again.
• If a new washing programme is to be se-
lected, check that there is detergent in the
detergent dispenser.
End of the washing programme
• The appliance will automatically stop and
an audible signal informs you of the end of
the washing programme.
1. Open the appliance door. The digital dis-
play shows zero.
2. Switch of the appliance.
3. Leave the appliance door ajar for a few
minutes before removing the dishes. This
way they will be cooler and the drying will
be improved.
Standby mode
If you do not switch off the appliance at the
end of the washing programme, the appli-
ance automatically goes into standby mode.
The standby mode decreases energy con-
sumption.
Three minutes after the end of the pro-
gramme, all indicator lights go off and the
digital display shows one horizontal bar.
14
electrolux
