Service
Should you require service on your Electrolux vacuum,
please telephone Electrolux Customer Care HELPLINE
on 0800 222 825. Before requesting service, please check
whether your problem can be resolved in the Trouble
shooting section on page 10.
New filter pads, brush rolls and drive belts can be obtained
from Electrolux Retailers. If difficulty is experienced in
obtaining spares, please contact Electrolux Customer Care
HELPLINE.
Service Checklist
• If your vacuum will not operate, check the plug
connection and mains fuse.
• Never allow the dustbin to become so full that it impedes
the air flow, thus reducing the cleaning efficiency of the
machine. The character of household dust and its effect
on the air flow through the machine may vary
considerably. Fluffy dust allows air to pass through
readily whereas fine powdery dust or proprietary cleaning
powders pack tightly in the dustbin, offering greater
resistance to air flow and will reduce cleaning efficiency
if the cup becomes overloaded.
• Always store your vacuum and spare dust filters in a
dry place.
• Renew the filter pads regularly. This is essential toensure
continued high filtration of dust particles.
•
Sucking up such items as stockings, clippings of cloth,
sizeable pieces of paper, wrappings from cigarette
packets or sweets etc., may block the hose. Electrolux
regrets that the clearing of blocked hoses cannot be
regarded as service that can be given free of charge,
under the warranty. Should a blockage occur, first
disconnect the vacuum from the electricity supply, refer
to section headed “How to Clear a Blockage”. If these
operations are not successful, contact Electrolux
Customer Care HELPLINE 0800 222 825.
•
Never pick up hot cinders or lighted cigarette ends.
•
Make certain that your vacuum does not come into
contact with water or any other liquid. It is not
designed as a wet pick up vacuum, and must never
be used on damp carpets or wet floors.
Important - in the event of the mains supply cable of this
vacuum requiring replacement, we recommend that this
be carried out by Electrolux Service Staff.
Spares
New filters, brush rolls and drive belts can be obtained
from Authorised Electrolux Dealers and electrical retailers.
If difficulty is experienced in obtaining spares please call
Electrolux Customer Care HELPLINE 0800 222 825. or
visit our website at www.electrolux.co.za
9
How to Maintain Mini turbo nozzle
Thermal Cut-Off
This vacuum has a special thermostat that protects the vacuum in case of motor overheating. If the vacuum switches off,
turn the switch to off position and unplug the vacuum. Check the vacuum for a possible source of overheating such as a
full dustbin, a blocked hose or clogged filter. If these conditions are found, fix them and wait at least 30 minutes before
attempting to use the vacuum. After the 30 minute period, plug the vacuum back in and push the on/off switch On ( I ). If
the vacuum still does not run, please call Electrolux Customer Care Helpline.
1) Turn nozzle onto back
side. Remove 1
screw.
2) Rotate lower part of
cover down over
brush and lift off cover.
3) Clear blockage from
brush roll area. Use
scissors to clip
threads or hair.
4) Place cover back into
position. Tighten
screw.
