Electrolux Air-O-Chill 10GN1/1, Installation And Operation Instruction Manual

Page: 25 / 34

5958 992 00
EN
25
1:00'
Note :
- The cooking cycles (steam, combi, convection and regenera-
tion) cannot be started until the steam generator is ready, as indi-
cated by the corresponding light off (see par. 4.1).
During this period the time count does not start and the
Start
cooking button flashes; this occurs also when the oven door is
opened.
Caution ! Risk of burns.
Always open the door with caution when the oven is hot.
4.3.3 STOPPING THE COOKING CYCLE - AUTOMATIC
At the end of the set time, the cooking cycle automatically stops
and the oven bell sounds continuously.
Open the door and remove the product.
Caution ! Risk of burns.
Always open the door with caution when the oven is hot.
Notes :
- The bell can be stopped in advance by carrying out any opera-
tion on the control panel or by opening the door.
The cooking cycle can be stopped
manually by keeping the cycle
Start/Stop button pressed for 2 seconds.
Shorter presses will be ignored by the oven.
A cycle identical to that just completed can be repeated by press-
ing the
Start/Stop button again.
4.4 MANUAL (Manual control)
SETTING COOKING CYCLE
The MANUAL control mode is used to carry out food cooking
manually by setting the various parameters of a cycle.
The food is cooked by heating it and can occur in a certain MODE,
with a givenTEMPERATURE, TIME and also HUMIDITY. There-
fore these factors must be set in order to perform a COOKING
CYCLE.
The oven works mainly by carrying out the operations given in
the following sections:
— SETTING COOKING CYCLE —-
- SELECTING COOKING MODE
- SETTING COOKING TEMPERATURE
- SETTING COOKING TIME
- SETTING AND USE OF CORE PROBE
- SETTING COOKING HUMIDITY
- MICROWAVE SETTING
- STARTING THE COOKING CYCLE
There are also other sections containing instructions on support
functions, such as:
- MANUAL CYCLE (CONTINUOUS COOKING)
- PREHEAT
- UTILITY
- COOKING PHASES IN AUTOMATIC SEQUENCE
Note:
In certain cooking cycles some cooking parameters (humidity,
temperature, etc.) cannot be selected.
4.4.1 SELECTING COOKING MODE
1) Press the button P2 ( ) several times and select one of the
following cooking modes by turning knob K.
CONVECTION
COMBI
STEAM
300
100
100
MICROWAVE
REGENERATION
PAUSE
COMBI is selected in the figure.
For a description of the various cooking modes, refer to par. 3.3
MAIN COOKING MODES.