Electrolux 95 EX-T, Instruction Booklet

Page: 14 / 20

1 4
Fig. 15
Fig. 17
Instructions for the Installer
Installation
It is important that all operations are carried out by qualified
personnel, in the normal manner.
The specific instructions are describred in the chapter on
installation. Before using the unit, take off the special protective
layer which protects the stainless steel and anodyne tin parts.
The following instructions are meant for a qualified installer, in
order that the operations of installation, regulation, and service
are executed according to the existing regulations.
Whenever changes are mode involving the disconnection of the
machine it is necessary to proceed with maximum caution.
THE MANUFACTURING COMPANY DECLINES ANY
RESPONSABILITY FOR POSSIBLE DAMAGES
RESULTING FROM AN INSTALLATION WHICH
DOESN'T COMPLY WITH THE RULES IN FORCE
Installation Environment
Warning - This unit can be installed and can work only in
constantly ventilated rooms, according to rules in force. In order
to make the gas unit work properly, it is necessary that air
sufficient to gas combustion can naturally flow in the room. (The
installer must follow the rules in force).
Positioning
This appliance belongs to the class "X".
It has been designed to be placed close to furniture units not
exceeding the height of the working level (EN 60 335-2-6).
Levelling
The appliance is provided with adjustable small feet placed in
the back and front corners od the base.
By adjusting the small feet (Fig. 15) it is possible to change the
height of the appliance so as to ensure a better levelling with
other surfaces and a uniform distribution of the liquids
contained in pans or pots.
Balancing the crystal lid
The crystal lid can be dissasembled to allow a better cleaning (
see Fig. 16). Clean the crystal lid only with warm water and avoid
the use of rough cloths or abrasive substances.
After a proper cleaning, carefully reposition the lid into its hinges.
The models provided with crystal lids are equipped with specially
balanced springs, inserted in the hinges at the back of the
appliance, to allow the lid to be closed smoothly and easily. You
can use a screwdriver to adjust the closure of the lid. The
necessary force for opening/closing the lid can be increased by
turning the adjusting screw 2 or 3 times as shown in Fig. 17.
Warning! The crystal lid can splinter when
overheated. Always ensure all the burners are off
before closing it.
Lid cleaning (Model 95 G)
The cooker lid can be disassembled to allow a better cleaning
(Fig. 18). After a proper cleaning, carefully reposition the lid into
its hinges.
Fig. 18
DO NOT clean the oven door while the glass panels
are warm. If this precaution is not observed the glass
panel may shatter. If the door glass panel becomes
chipped or has deep scratches, the glass will be
weakened and must be replaced to prevent the
possibility of the panel shattering. Contact your local
Service Centre who will be pleased to advise further.
Models in stainless steel or aluminium:
We recommend to clean the oven door using only a wet
sponge and dry it up after cleaning with a soft cloth.
Never use steel wool, acids or abrasive products as they
can damage the oven surface.
Clean the oven control panel following the same
precautions.
Fig. 16