Installation Instructions
This appliance must be installed by an
authorised person and in compliance with :
1.
AS 5601 ʻGas Installationsʼ (Australia) or NZS
5261 ʻInstallation of Gas Burning Appliances
and Equipmentʼ (New Zealand)
or the relevant
installation code for gas appliances of your
country.
2. The local gas fitting regulations, municipal
building codes, electrical wiring regulations and
any other relevant statutory regulations.
3. The particular instructions as given below. Before
commencing installation, check to ensure that the
appliance gas type given on the data plate on the
appliance corresponds with the type of gas to which
it is intended the appliance be connected.
4. A certificate of compliance MUST be given to the
customer after the appliance is successfully
installed.
Installation Procedure
1. The
bench cutout
should be made as per ʻBENCH
CUTOUT SIZEʼ table (Figure 4).
2.
Adjacent walls, cupboards and protection for
combustible materials.
Refer to the Requirements of AS 5601 Section 5.12.1
regarding the necessary clearances.
3.
Optional Barrier.
A barrier can be installed to prevent
accidental contact with the cooktop base, where the base of
the cooktop is accessible from below (ie inside a cupboard,
etc). Impressions have been incorporated into the base to
ensure a minimum clearance of 10mm is maintained
between the base and the barrier. This barrier may be
made of any rigid material.
Ensure that the appliance is installed with Section 5.12.1 of
AS 5601 (Australia) or section 14.1 of NZS 5261 (New
Zealand), regarding clearances to combustible surfaces
and materials, and clearances to rangehoods and exhaust
fans.
To ensure clearances of 200mm from burners to vertical
combustible surfaces observe the dimensions shown in
Figure 5.
Clearances to combustible materials may be reduced if
combustible surfaces are protected in accordance with
clause 5.12.1.2 of AS 5601 (Australia) or section 14.1.2 of
NZS 5261 (New Zealand).
4.
Fitting the cooktop into the bench.
Carry out as follows:
• Place the seals supplied around the bench cut-out as
shown in Figure 6. Position them 6mm from the side
edges and 14mm from the front and rear edge, taking
care that the seals meet without overlapping.
7.
INSTALLATION
130
min
490
19
570
37
135
min
120
min
470
19
830
27
Gas supply connection
*
Figure 5
Figure 4
Gas supply connection
14mm
6mm
seal
14mm
6mm
bench cut-out
Figure 6
