Electrolux 603877, Installation And Operating Manual

Page: 39 / 46

39
M APPLIANCE CLEANING
M.1 Precautions for cleaning
WARNING
Refer to “ Safety Information “
Use specific gloves for high tem-
perature. Refer to “C.9
Personal
protection equipment “.
IMPORTANT
The cleaning has to be done with the appliance in
high temperature to guarantee the efficiency of the
cleaning product.
Use the specific cleaning kit. The manufacturer
recommends for cleaning “Rapid Grease C41
(0S2292)“.
Never immerse cords, plugs or appliance in water.
M.2 External cleaning
NOTE!
To easily clean the appliance, remove the dirty
when it has just formed.
• Do not use steel wool, abrasive powders or chemical
products such as sodium hypo chlorite (bleaching powder),
hydrochloric acid (muriatic acid) or other acids to clean the
surfaces of the appliance.
• These products rapidly and permanently damage the steel
or aluminum.
• Do not use the above products even for cleaning zones next
to the appliance, their vapors can damage it.
• In case of encrusted dirt, grease or sandwich residue, use a
cloth/sponge wiping with the grain of the satin finish and
rinse often.
– Rubbing in a circular motion combined with the particles
of dirt on the cloth/sponge could damage the steel’s satin
finish.
• Clean both sides and the back of the appliance. Take care
not to introduce water into the appliance through the
openings.
M.3 Glass cleaning in use
CAUTION
Lighting risk :
Grease and carbon deposit can be burnt
due to the microwave. It is strongly
recommended to remove all the debris in
the cooking area.
Do not use any razor blade or metallic tool
on the glass, it will be damaged.
If the glass is too much dirty:
1. Remove the grease and burned deposit with the scraper.
Do not use any razor blade or metallic tool.
2. Sweep the dirty with the Teflon brush.
3. Wipe the glass and the metallic frame with a damp cloth.
M.4 Daily cleaning
Glass and working top cleaning
1. Switch the appliance OFF and unplug the power cable.
Allow the machine to cool down 10 minutes before
proceeding: protection devices like high temperature
gloves are needed when operating with hot parts;
2. Open the lid and insert a cloth-paper into the slot between
the worktop and the lid to prevent food residues from
ending up there;
3. Spray the detergent on the glass by means of the
delivered sprayer. Allow to soak for 1 minute. The glass
must be hot to achieve the effective degreasing;
4. Scrub the surface of the glass with the specific scraper, an
abrasive sponge or pad.
CAUTION
The specific scraper is only to be used
for cleaning.
IMPORTANT
Have high care not to touch the silicon sealing:
that would scratch, cut or damage it and provoke
grease/dirt infiltrations. Do not use any razor
blade or metallic tool.
30°C
86°F
1
2
DETERGENT