11
Troubleshooting
Before You Call for Service
If the appliance appears to be malfunctioning, read
through this manual first. If the problem persists,
check the
Troubleshooting Guide below. Locate
the problem in the guide and refer to the cause and
its remedy before calling for service. The problem
may be something very simple that can be solved
without a service call. Some remedies listed in the
Troubleshooting Guide are very complex. Consulting
or contracting a qualified service technician may be
necessary.
If Service is Required
Contact the dealer where you purchased the
appliance if service is required. State the model and
serial number and explain the problem. The model and
serial number plate is located on the ceiling of your
appliance.
If you do not know the name of the selling dealer or a
local service company, you can check online at
www.
electroluxicon.com, or call 1-877-435-3287.
WARNING
ELECTROCUTION HAZARD
NEVER attempt to repair or perform maintenance on the unit until the main electrical power has been
disconnected.
Problem
Possible Cause
Remedy
Appliance
not cold
enough
• Control set too warm
• Airflow to front grille
blocked
• Door gasket not sealing
properly.
• Adjust temperature colder. See “
Adjusting the
Temperature” in the “Start-Up and Temperature Control”
section. Allow 24 hours for temperature to stabilize.
• Airflow must not be obstructed to front grille. See
“
Installation” Section.
• Adjust door gasket.
Appliance
too cold • Control set too cold
• Adjust temperature warmer. See “
Adjusting the
Temperature” in the “Start-Up and Temperature Control”
section. Allow 24 hours for temperature to stabilize.
No interior light
• Failed LED assembly
• Contact a qualified Electrolux Service Technician.
Light will not go out
when door is closed
• Door switch not making
contact
• Check for proper door alignment.