9
Prohibition
Meaning
Keep the area around the appliance clear and free from
combustible materials. Do not keep flammable materials in
the vicinity of the appliance
Install the appliance in a well-ventilated place to avoid the
creation of dangerous mixtures of unburnt gases in the
same room
Danger
Meaning
caution, hot surface
danger of electrocution (shown on electrical parts with
indication of voltage)
End of use
• When the appliance is no longer to be used, make it unusable by removing the mains
power supply wiring.
A.6
Transport, handling and storage
• Due to their size, the machines can be stacked on top of each other during transport,
handling and storage by complying with that specified on the slip placed on the packing.
• Do
not
stand
under
suspended
loads
during
loading/unloading
operations.
Unauthorised personnel must not enter the work area.
• The weight of the appliance alone is not sufficient to keep it steady.
• For machine lifting and anchoring, do not use movable or weak parts such as: casing,
electrical raceways, pneumatic parts, etc.
• Do not push or pull the appliance to move it, as it may tip over.
• Machine transport, handling and storage personnel must be adequately instructed and
trained regarding the use of lifting systems and personal protection equipment suitable
for the type of operation carried out (e.g. overalls, safety shoes, gloves and helmet).
• When removing the anchoring systems, make sure the stability of the machine parts
does not depend on the anchoring and, therefore, that this operation does not cause the
load to fall off the vehicle. Before unloading the machine components, make sure all the
anchoring systems are removed.
• Machine positioning, installation and disassembly must be carried out by specialised
personnel.
A.7
Installation and assembly
• The operations described must be carried out by personnel qualified (refer to D.9
Characteristics of personnel trained for normal machine use
) in compliance with the
current safety regulations, regarding the equipment used and the operating procedures.
• The plug, if present, must be accessible after positioning the appliance in the place of
installation.
• Disconnect the appliance from the power supply before carrying out any installation
procedure.
