Maintenance
6.
1
MECHANISM
• The vegetable peeler only requires a minimum amount of
maintenance (the bearings of the motor and mechanism are
greased for life).
• It is recommended that the following be checked at least once
a year :
- The condition of the flexible water inlet pipe and its attachment.
- He wear of the belt.
• To access the mechanism, motor and electrical components :
- Disconnect the machine.
- Detach the machine from the stand, if fitted (4 attachment
screws).
- Turn the machine over and remove the 4 screws which attach
the base.
• Changing the toothed belt :
- Unscrew by 2 turns the 2 motor attachment screws (10 mm
hexagonal spanner).
- Bring the motor closer and slide onto the drive pulley to remove
the belt.
- Fit a new belt.
-
Lightly
tension the belt, using a screwdriver as a lever between
the motor and the bearing.
- Retighten the 2 motor attachment screws.
• The capacitors may retain an electrical charge. To avoid
taking any risks when carrying out work, we recommend
discharging them by connecting their terminals with an insulated
conductor (e.g. a screwdriver).
Residual voltage at the capacitor terminals.
ATTENTION!!
Unplug the machine before carrying out any operation.
All access to the electrical parts requires the use of a tool.
Maintenance may only be carried out by a qualified, trained and authorised person.
T5S GB 02 2021
6
6.
2
MAINTENANCE OF THE EQUIPMENT
•
ABRASIVE PLATE :
Inefficient
- Used ramps or worn abrasive layer which has revealed the
base of the plate (poor peeling of the vegetables and formation
of flats): change the plate.
- dirty plate (calcium, starch or soil deposits): brush the plate.
•
KNIFE PLATE :
resharpening of the blades
- Remove the attachment screws.
- Use a water cooled grinding wheel , taking care to keep the
same cutting angle
•
WASHING PLATE :
Damaged or worn edges
- Change the brush.
- Unscrew the two attachment screws underneath the plate and
remove the brush.
After sharpening several times, the thickness of the
cut will increase. Replace worn blades.
6.
3
ADJUSTMENT OF THE SAFETY DEVICES
• Check that the safety devices are operating correctly on a
regular basis. The motor should stop :
- when the lid is opened.
- when the door is opened.
• If either of the two safety devices do not work :
- do not use the machine.
- Have it adjusted by the service department of your local
dealer.
S1 : Door safety device
S2 : Lid safety device
M
: Motor
CPu : Power card
Mi
: Timer
CD : Start-up condenser
CP : Permanent condenser
MA : Start-up relay
Fu : Fuse
6.
4
ELECTRICAL COMPONENTS
See electrical diagrams.
•
Identification of the colours of the wires :
- Power circuit : black
- Control circuit : red or colour wire cable :
(D) brown / (E) grey / (F) white
- Motor
: A : blue / B : red / C : black / D : brown
- Phase
: L1
- Neutral
: N
- Earth
: B/C green /yellow
•
Identification of the components :
O
: Stop button
I
: Start button
6.
4
