Electrolux Professional 603877, Installation And Operating Manual, Page: 37 / 46

37
Maintenance, inspections, checks and
cleaning Frequency Responsability
Ordinary cleaning
• general cleaning of appliance and surrounding
area
• Daily • Operator
Mechanical protection devices
• check their condition and for any deformation,
loosening or removed parts
• Monthly
• Service
Control
• check the mechanical parts, for cracks or
deformations, tightening of screws: check the
readability and condition of words, stickers
and symbols and restore if necessary
• Yearly
• Service
Appliance structure
• tightening of main bolts (screws, fixing sys-
tems, etc.) of appliance
• Yearly
• Service
Safety signs
• check the readability and condition of safety
signs
• Yearly
• Service
Electrical control panel
• check the electrical components installed
inside the electrical control panel. Check the
wiring between the electrical panel and appli-
ance parts
• Yearly
• Service
Electrical connection cable and plug
• check connection cable (replace it if neces-
sary) and plug.
• Yearly
• Service
General appliance overhaul
• check all components, electrical equipment,
corrosion, pipes…
Every 10 years
1
• Service
Preventive maintenance
• remove any deposits of dirt inside the
appliance.
Every 6 months
2
• Service
Control
• check the conditions of the internal parts.
• check and clean the discharge system.
Every 6 months
2
• Service
1. The appliance is designed and built for a duration of about 10 years. After this period of time (from commissioning) the appliance must undergo a general
inspection and overhaul.
2.
In particular conditions (e. g. intensive use of the appliance, salty environment, etc.) the preventive maintenance should be more frequent.
L.5 Periods of non-use
If the appliance is not going to be used for some time, take the
following precautions:
• disconnect the power supply or remove the plug from the
power socket, if present;
• carry out a thorough cleaning, following both the daily and
weekly cleaning guidelines described in this manual.
• after finishing the deep cleaning, insert the high temper-
ature silicone pad into the appliance to protect the glass.
• remove the frontal bezels and clean / replace the cooling air
intake filters
• periodically air the premises.
M TROUBLESHOOTING
M.1 Introduction
Certain faults may occur during normal use of the appliance. In
some cases, faults can be eliminated easily and quickly by
following the indication below.
The display, if present, always shows a warning message or
alarm describing the occurring fault.
With some anomalies, you can hear some acoustic signals.
Warnings icon
If the fault persists, contact the Customer Care Service:
1. Disconnect the appliance from the main power supply;
2. Switch off the safety circuit breaker ahead of the
appliance;
3. Remember to specify:
• the type of fault
• the appliance PNC (product number code)
• the Ser. No. (appliance serial number).
IMPORTANT
The appliance PNC and serial number are essential
for identifying the type of appliance and date of
manufacture.
!