Electrolux Professional 603877, Installation And Operating Manual, Page: 21 / 46

21
Fig. 1 Display structure
NOTE!
This display is not a touch screen.
To select the desired program, press the relevant
side button.
The appliance has 8 preset programs. To modify them refer to
paragraph I.5
Advanced settings .
H.3 Non-stick tray
The tray allows to keep cleaner the appliance and reduce the
cleaning time.
IMPORTANT
The tray is strongly recommended for use with this
appliance.
You can also use a sheet of baking paper on the glass, to
protect it from food residue.
Place the baking paper on the glass:
NOTE!
It is not necessary if you use the provided tray.
1. Clean the glass (refer to K.3.2 Glass and lid ).
2. Lay the baking paper on the glass.
It must cover only the glass surface, do not exceed over
the glass surface.
I OPERATING
WARNING
Refer to “ Warning and safety
information “.
I.1 Start up
Press the ON/OFF button to switch on the appliance.
• The display shows first the “Welcome“ screen;
• The lid opens automatically.
The preheating takes about 20 minutes;
• During preheating, the appliance shows the QR code,
which you can scan to register the product or access the
documents you need;
NOTE!
You can recall the QR code at any time by the
programs page and pressing the button 1 and 3 at
the same time for 2 seconds (refer to Fig. 1
Display
structure ) or by entering the setting menu with the
provided password and pressing the icon .
• During this time, it is not possible to carry out any action.
• At the end of the preheating mode the display shows all the
available programs.
The appliance is now ready to use.
I.2 Set a program
• To start the required program, close the lid and press the
corresponding program button.
IMPORTANT
According to your model, the keyboard may be
different. In this case, consider that the “3/4“ button
corresponds to number“ 3“ and “S“ button corre-
sponds to number “4“ while setting the programs.
NOTE!
The symbol “-“ means that the program was
deleted.
To set up a program enter a cycle duration.
To delete a program, reset the cycle duration.
• When the cycle starts, the display shows the following
information: