29
ENGL
ISH
J6
Operation
The filling and heating stage has finished when the
display shows the tank temperature:
The appliance is then ready for use:
•
Open the door.
•
Pour the required amount of detergent non-foaming
into the tank.
•
Insert the dirty pans and containers upside down
on the basket.
•
Arrange dishes in the rack, avoiding washing
decorated dishes, silverware in contact with other
metals and the drying of food residuals on dishes.
IMPORTANT
Remove large food scraps from the dishes to pre-
vent clogging the filters.
•
Pre-wash the dishes by spraying them with cold or
lukewarm water, without using any detergent.
•
Insert the rack containing the dirty dishes.
Increase / decrease the water pressure
For washing light pots:
-
unscrew the wing nut "X" (Figure 20);
-
press the limiting valve "Y" (Figure 20) inward to
reduce the water pressure in the lower wash arm
and thus increase the water pressure in the upper
wash arm, so that the pots remain in their position.
-
retighten the wing nut "X" (Figure 20).
For washing large and heavy pots:
-
unscrew the wing nut "X" (Figure 20);
-
remove the limiting valve "Y" (Figure 20);
-
retighten the wing nut "X" (Figure 20).
Figure 20 Wash water pressure adjustment
•
Close the door and select the suitable wash cycle;
the corresponding indicator light comes on and the
wash cycle starts.
Usable wash cycles:
-
Automatic cycle I
For lightly soiled pans: press button “G” (see Table 2
“Control panel” and table of times).
- Automatic cycle II
(recommended)
For normally dirty pans: press button “H”(see Table 2
“Control panel” and table of times).
- Automatic cycle III
For very dirty pans: press button “I” (see Table 2 “Con-
trol panel” and table of times).
- Manual cycle IV
For particularly dirty pans with dried food residue, pans
with a special shape or for other specific needs of the
user: press button “L” (see Table 2 “Control panel”),
which initiates a continuous wash until the operator
selects an automatic cycle.
•
To stop the wash cycle, just press the selected cycle
button or open the door.
•
To continue the wash cycle, just press the selected
cycle button or close the door. The cycle starts
again from where it stopped.
•
At the end of the wash, the dishwasher emits a series
of beeps and “END” blinks on the display:
open the door and remove the basket containing
the clean pans.
IMPORTANT
The appliance will not remove burnt food deposits
from dishes. Dishes with burnt-on food deposits
should be cleaned mechanically/chemically (for
example, pre-wash under running water) before
putting them in the dishwasher.
IMPORTANT
The use of “foaming”/non-specific detergents or in
any case detergents used in different ways from that
prescribed by the manufacturer, can cause damage
to the dishwasher and compromise washing results.
IMPORTANT
Failure to remove the residuals of detergent possibly
used for manual prewash can cause malfunctioning
of the dishwasher and compromise washing results.
Change the water in the tank at least twice a day.
55
Y
X
End
Summary of Contents for 506048
Page 32: ...34 ...