Variplex™-XL 3-Way Screen System
V
ariple
x™ XL 3-
W
ay Screen System
Figure 2—Low Frequency Wiring
Configuration
4. Slide to two units together, with the backs
almost touching and the front slightly appart.
Engage the brace to the other speaker and
tighten the bolt. Pull the front of the units
together. Pass the 1/4-20 x 1 1/2 inch bolts
through the holes opposite the T-nuts in each
of the enclosures front baffle inside edge.
(see figure 1) Tighten bolts unitl a 1/16 inch
remains between the two enclosures.
5. Now that the Low frequency units are at-
tached, the input panels can be connected.
(See Figure 2 for referance) There are three
wiring configurations possible. The speak-
ers maybe wired in Series with one amp
channel input or wired in Parallel with one
amp channel input. Finally they may be
wired seperately, each speaker on one amp
channel. (NOTE: Use red jumper plugs
but, do not us wire jumpers between J1
and J2 when using this particular configu-
ration.)
Series wiring configuration: Connect J1 to
J1 and J2 to J2, using supplied wire jumper.
Select the supplied white jumper plug and
the yellow jumper plug. The white jumper
plug is to be installed on the speaker which
has T1 and T2 connected to the amplifier
source. The yellow jumper is installed on the
other speaker, for a nominal impedance of
12 ohms.
Parallel wiring configuration: Connect J1
to J1 and J2 to J2, using supplied wire
jumper. Select the two supplied red jumper
plugs and install one in each of the input
panels.
The amplifier source may be connected to
either input panel at T1 and T2, for a nomi-
nal impedance of 2.8 ohms.
Seperate wiring configuration: Do not con-
nect J1 to J1 amd J2 to J2. Select the two
supplied red jumper plugs and install one in
each of the input panels. The individual am-
plifier channels may be connected to each
of the input panels at T1 and T2 for indivdual
nominal impedances of 6 ohms.
