EVOLVE Wall mount kit
Wiring and installation | en
13
Electro-Voice
Installation Manual
2022-03 | 02 | F.01U.401.529
2.
Strip back each individual wire’s insulation to leave approximately 6 mm of bare wire
exposed.
3.
Twist the wire ends to prevent individual strands from separating.
4.
Insert the bare wire into the input terminal connector.
Make sure no excess bare wire is exposed beyond the terminal connector. The connector
must clamp down on the bare wire, not the wire insulation.
5.
Install the rubber grommet on the cable and attach the Phoenix-style connector to the
wire. Connect the positive wire to the pin marked with a "+", and the negative wire to the
pin marked with a "-".
6.
Plug the connector into the lower housing of the column speaker adapter.
6 - 8 mm
1,5mm² - 2,5mm²
(AWG16-AWG14)
1
+
1
+
2
-
2
-
7.
Attach the strain relief clamp using TR20 screws.
8.
Replace the upper housing of the column speaker adapter onto the set.
