EVC Variable-Intensity Loudspeakers
Installation | en
11
Electro-Voice
Installation manual
2019-10 | 04 | F.01U.378.116
All hardware supplied by the user must be rated for overhead lifting to suspend the
loudspeaker system.
To install the eyebolts, do the following:
1.
Remove the
three M10 flat-head bolts (A)
from the fly points on the top of the enclosure.
A
2.
Screw the lifting
eyebolt with fender washer
into the threaded attachment point until
the fender washer makes contact with the enclosure.
Never install the eyebolt without the washer included with the eyebolt kit.
3.
Finger tighten the
eyebolt
until the correct alignment position is obtained.
A maximum of one complete turn.
4.
Install a
safety cable
.
Eyebolts orientated in the plane of pull
!
Caution!
Eyebolts must be fully seated and oriented in the plane of pull. Always use the fender washer
included with the eyebolt kit to distribute the load on the enclosure.
Excessive tightening of the eyebolt with a wrench, screwdriver or other tool, can result in a
system failure and possible injury.
Figure
4.4: Fully seated eyebolts with washers, with correct orientation in the plane of pull (Correct; left,
Incorrect; right)
