To install an eyebolt, do the following:
1.
Remove the fly point cover from the loudspeaker.
Repeat this step for all three fly point covers.
2.
Screw the lifting eyebolt and M10 washer into the insert until the washer has contacted
the exposed surface.
Repeat this step until all three eyebolts and three washers are inserted.
3.
Using your fingers, tighten the eyebolt until correct alignment position is obtained, a
maximum of one complete turn.
Repeat this step until all three eyebolts are tightened.
Notice!
Use certified hardware rated for overhead lifting to suspend the loudspeaker.
A
B
C
Figure 2.3: Examples of useful suspension hardware
A: Anchor shackle
B: Threaded chain connector
C: Carabiner-type snap hook
en
13
Electro-Voice
Installation note
2017.12 | 02 | F.01U.332.445
