- Main Control -
BYPASS Footswitch & LED
–
The LED illuminates when the effect is
engaged. The LED will not light if the Nano Battalion is bypassed. Press
the footswitch to toggle between effect on and buffered bypass mode.
VOL Knob –
Sets master output level of the pedal.
BLEND Knob
– Sets the ratio between clean signal and distorted signal.
Turn BLEND up for more distorted signal.
DRIVE Knob –
Sets the intensity and saturation of the distortion.
TONE Knob –
Cuts high frequencies from the distortion as you turn the
knob down.
EQ CONTROLS:
TREBLE Knob
– Boost or cut high end. No effect when the knob is at
50%. Boosts/cuts frequencies starting above 1kHz. Maximum boost/cut
about +/-12dB around 5kHz.
BASS Knob –
Boost or cut low end. No effect when the knob is at 50%.
Boosts/cuts frequencies starting below 200Hz. Maximum boost/cut
about +/-12dB around 60Hz.
MID Switch –
No effect when the switch is in the middle position. In
the upwards position, 9dB boost around 500Hz. In the downwards
position, 9dB cut around 500Hz.
- EQ POS. & Signal Path -
The EQ POS switch determines where the EQ (TREBLE, BASS, and MID
controls) falls in the Nano Battalion’s signal path. In all cases, the TONE
control comes immediately after the distorted signal, and the VOL control
is last in the signal path. There are three EQ POS modes, illustrated on
the next page.
