FCC COMPLIANCE
Note:
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help
.
Modifications not expressly approved by the manufacturer could void the user's
authority to operate the equipment under FCC rules.
GOOD VIBES
Analog Modulator
Congratulations on your purchase of the Good Vibes, a re-creation of classic
1960’s era Chorus/Vibrato! This circuit’s original foundation is preserved
through the use of photocells and internally-boosted power-rails. The result
is anything from wiggly vibrato, to subtle leslie and ultra-lush chorus that is
out of this world! True Bypass and LED indication have also been added,
along with an expression pedal input for selectable control over speed or
intensity.
WARNING:
Your Good Vibes comes equipped with an Electro-Harmonix 9.6DC-200
power supply (same as used by Boss
®
& Ibanez
®
: 9.6 Volts DC 200mA). The Good
Vibes requires up to 45mA at 9VDC with a center negative plug. Using the wrong
adaptor may damage your unit and void the warranty. The Good Vibes does not
accept batteries.
VOLUME Knob –
controls the output volume. Maximum setting is slightly
above unity-gain.
SPEED Knob –
controls the speed of modulation. As you turn SPEED
clockwise, the modulation rate increases. The LED to the left of the SPEED
knob flashes at the modulation rate (even in bypass).
INTENSITY Knob –
allows you to set the depth of modulation sweep. As
you turn INTENSITY clockwise, the modulation depth increases.
CHORUS-VIBRATO Switch –
when this switch is set to Vibrato, the Good
Vibes delivers pure pitch-modulation. When this switch is set to Chorus, the
Good Vibes delivers a lush, vibe-like chorus.
FOOTSWITCH and LED
– The Footswitch toggles the Good Vibes between
effect and True Bypass mode. When the effect is engaged, the LED is lit.
INPUT Jack –
This ¼” jack is the audio input for the Good Vibes. The input
impedance is 500kΩ.
OUTPUT Jack –
This ¼” jack is the effect output for the Good Vibes.
Summary of Contents for GOOD VIBES
Page 3: ......
