Page
3
of
7
SAFETY INSTRUCTIONS
Important!
Carefully read the instructions before operating the unit
This appliance is for indoor use only.
Rating: This unit must be only connected to a 220-240 V / 50 Hz earthed outlet.
Installation must be in accordance with regulations of the country where the unit is
used.
If you are in any doubt about the suitability of your electrical supply have it checked
and, if necessary, modified by a qualified electrician.
This fan has been tested and is safe to use. However, as with any electrical appliance
- use it with care.
Disconnect the power plug from socket before dismantling, assembling or cleaning the
unit
Avoid touching any moving parts of the appliance.
Never insert fingers, pencils or any other objects though the guard
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities. It is also not intended for use by those with a
lack of experience and knowledge, unless they have been given supervision or
instruction concerning the use of the appliance by a person responsible for their safety.
Do not leave children unsupervised with this appliance.
Do not clean the unit by spraying it or immersing it in water.
Never connect the unit to an electrical outlet using an extension cord. If an outlet is not
available, one should be installed by a qualified electrician.
Never operate this appliance if the cord or plug is damaged. Ensure the power cord is
not stretched or exposed to sharp object/edges.
A damaged supply cord should be replaced by the manufacturer or a qualified
electrician in order to avoid a hazard.
Any service other than regular cleaning should be performed by an authorized service
representative. Failure to comply could result in a voided warranty.
Do not operate the fan unassembled without protective front and rear grilles in
position.
Do not use the appliance for any other purposes than its intended use.
Never use the mains plug as a switch to start and turn off the fan. Use the provided
ON/OFF switch located on the control panel.
Always place the unit on a dry and stable surface. Do not move or tilt the unit
High Velocity fans are designed to create rapid air movement, therefore make sure the
fan is not placed near curtains or any objects that may be drawn into the fan inlet.
The appliance should not be installed in laundry or wet rooms
Do not use this unit in environments with flammable and explosive gases.
Avoid keeping the unit in direct sunlight for a long period of time
Energy Saving and Unit Safety Protection Tips
Do not cover or restrict the airflow. Do not use in dusty environment.
For maximum performance the minimum distance from a wall or objects should be
50cm.
Warning:
To reduce the risk of fire or electrical shock, DO NOT USE THIS FAN with any
SOLID STATE Speed Control Device or any variable speed controllers.