6
INSTALLATION
Check all the parts against the parts list. If parts are missing, please contact the supplier using
the information located on page KIHHIPHPIJHPI
This product MUST NOT be used if the power cable is damaged.
For ease of assembly only loosely tighten bolts and tighten fully when assembly is complete.
WARNING:
Do not over tighten bolts; only tighten with moderate pressure to avoid damaging the
bolts or components of the heater.
STANDING INSTALLATION
1. Attach the base pole (14) in to the base (17) with 4 M6x30 bolts (16).
2. Slide the base cover (15) over the base pole (14) until it rests over the top
of the base (17).
3. Attach the middle pole (10) to the base pole (14) using the 1 M6x6 bolt (13).
4. Slide one of the cable clips (12) over the top of the middle pole (10).
5. Attach the upper pole (7) to the middle pole (10) using 1 M6x6 bolt (9).
Slide onto the upper pole one cable clip (8).
6. Attach the heater (1) to the upper pole (7) using 1 M6x6 bolt and hand
tighten
7. Clip the cable into the 2 cable clips.
WALL MOUNTED INSTALLATION
Using a tape measure, measure the distance between all
4 points on the back of the heater. Make a note of the
measurements. Using these measurements, drill 4
corresponding holes into your chose installation location.
Keep in mind the length of the cable, and ensure that once
installed it can plug in safely.
Insert the 4 wall plugs provided and the 4 screws, leaving
some of the screw head protruding from the wall for
installation. Once complete, you can now hang your
heater onto the screws. Ensure the unit is secure before
proceeding with use.
