After setting the time and day, you can begin to program your
Eco.
At the top of the screen you will be able to see 7 triangles, one
for every day of the week. The programming screen always
starts from Monday at 0:00hrs.
Use the +/- keys to advance through the hours, from 0
–
24. The hour will flash to indicate
that it is currently selected. When an hour is selected, use the
,
☾
,
and
keys to set a
heat level for that hour.
Once the correct mode is selected for each
hour of the day, click the ‘PROG’ button to
accept the day and repeat the process for all of the days of the week.
Once the week is complete, the heater must be set to the program screen. If it is not
currently displayed, simply press the ‘P
ROG
’ button.
** The heater will only run in programming mode if it is left on this screen. **
Manual Heating Modes
Standby (stops heating operations)
Anti-Frost Mode (recommended temp. 5°C)
☾
Economy Mode (recommended temp. 16°C)
Comfort Mode (recommended temp. 20°C)
Pressing the
button switches the heater on and off. When it switches on, it will display
the last selected mode, which will often be the program screen.
Click
the ‘PROG’ button in order to enter
manual mode. (Note:
pressing and holding ‘PROG’ will enter programming
mode instead).
Once in manual mode, press the
Comfort button to adjust your
comfort temperature, the
☾
Economy button to adjust your economy
temperature, and the
Anti-Frost button to enter Anti-Frost mode.
Change the temperature of the selected mode using the +/- buttons. Once you have made
your changes, the radiator will operate continuously in the mode selected.
= two bars
☾
= one upper bar
= one lower bar
= no bar