Electric Co WDH-610HA, Manual

Page: 14 / 18

Problem Possible Cause Solution / Hint
Check that if the appliance’s
plug is properly connected to
a wall socket.
The appliance has no power
Check if the wall socket is
damaged.
Motor failure
Go to the store where the
appliance was bought.
The fan and the
compressor are not
working
Electronic fault
Go to the store where the
appliance was bought.
Air inlet filter blocked Clean the air filter.
Low level of refrigerant gas
Go to the store where the
appliance was bought.
Not collecting
water
Temperature and humidity are
too low
Turn off the appliance and
wait for the temperature to
rise.
Noise emission
during usage The surface where the
appliance is placed is irregular Place the appliance on a flat
a stable surface.
Dirty air filter Clean the air filter.
Frozen condenser
Temperature is too low
Turn off the appliance and
wait for the temperature to
rise.
Drainage tank (A) is not fitted
correctly Fit the drainage tank (A)
properly.
Micro switch failure
Go to the store where the
appliance was bought.
Water leakage
Frozen appliance
Turn off the appliance and
wait until the ice defrosts.
CLEANING
Air Filter
- The air filter must be regularly cleaned. This filter is behind the air inlet grid (B).
Note: for a daily use, the filter should be cleaned once a week.
- To remove the filter, remove the tank (A) and tip the appliance towards the rear at an
angle of approximately 15º. Hold the filter and pullet downwards (Fig. 4).
- Clean the air filter with water and place is back on the appliance.
Note: it is not necessary for the filter to be completely dry when you replace it in the
appliance.
14