Electric Bike Technologies E-BikeKit E-TrikeKit, Owner'S Manual And Installation Manual

Page: 13 / 28

13
•
•
•
•
ST1: display mile / km
ST2: speed limit in KM
ST3: wheel size (for speed / trip / ODO display on screen)
ST4: motor type (for speed / trip / ODO display on screen)
ST5: battery type (for battery meter display on screen)
ST6: assist level steps (default 0 - 5) – this controls how many notches you get – 3, 5, or 9, and what the
lowest setting is - a “0” setting that disables motor and PAS or 1 as the lowest.
ST7: current limit – controls the overall motor current maximum. This is for continuous. Peaks are al-
lowed to go above this by a couple amps. Turning down this setting essentially can reduce your “motor
wattage”
- you should set this to 20 usually
ST8: PAS settings (see above)
ST9: Drive - mode settings (Throttle only / PAS only / both throttle and PAS)
1 - 3 both (default)
1 - 1 PAS only (turn this on to disable throttle. Alternatively you could just unplug the
throttle… this could allow you to make the bike a California class 1 (20mph no throttle) or class 3
(28mph no throttle)
1 - 2 Throttle only (or just unplug the PAS sensor)
VO - 0 to VO - 5: custom voltage settings
Use this in conjunction with ST5 - DIY to fine - tune the voltage response for the battery meter
display or set up your own battery